Skip to main content
SNIJER

Part of Injection Molding

Insert Molding⁠

Insert moulding places a pre-made part — typically a metal thread, pin, contact or bushing — in the mould and moulds plastic around it, creating one strong component with no later assembly.

About this service

Metal inserts give plastic parts durable threads, electrical contacts and wear surfaces. Knurling, grooves or undercuts on the insert lock it into the plastic against pull-out and torque.

Inserts can be loaded by hand for prototype and low-volume runs, or automatically in series production.

Key capabilities

  • Threaded inserts, pins and contacts
  • Secure retention against pull-out and torque
  • No secondary assembly
  • Manual or automated loading

Typical applications

  • Connector housings
  • Threaded mounting points in plastic
  • Sensor and electronics housings

Materials

  • Brass inserts
  • Stainless steel pins
  • PA, PBT, PC, PEEK plastics

Frequently asked questions

Why insert-mould instead of pressing in threaded inserts afterwards?

Moulded-in inserts resist higher pull-out and torque loads and skip an assembly step. Pressed-in or heat-staked inserts are an alternative for low volumes where tooling cost matters more.

Related services

Overmolding

Overmoulding moulds a second material, usually a soft TPE or rubber, over a rigid plastic base part.