Skip to main content
SNIJER

Part of Sheet Metal Fabrication

Metal Bending⁠

Metal bending folds flat sheet along straight lines with a press brake to form angles, channels and boxes. It turns laser- or water-jet-cut blanks into finished three-dimensional parts.

About this service

CNC press brakes with angle measurement compensate for springback, so bend angles repeat across a batch. We plan bend sequences and tooling during the manufacturability review, and flag minimum flange lengths, bend radii and hole-to-bend distances that would cause trouble.

Bending is typically combined with laser cutting, welding and powder coating for a finished enclosure or frame delivered as one job.

Key capabilities

  • CNC press brake with angle control
  • Repeatable bend angles across a batch
  • Bend-sequence planning
  • Combined with cutting, welding and coating

Typical applications

  • Enclosures and control cabinets
  • Brackets and frames
  • Channels, trays and covers

Materials

  • Mild steel
  • Stainless steel
  • Aluminium
  • Copper and brass

Frequently asked questions

What is springback in bending?

Springback is the small elastic recovery of metal after bending. The press brake overbends by a calculated amount, and angle measurement corrects it, so the finished angle matches the drawing.

Related services

Laser Cutting

Laser cutting melts or vaporises sheet metal along a programmed path with a focused beam, giving fast, accurate cuts with fine…

Water Jet Cutting

Water jet cutting uses a high-pressure stream of water, usually mixed with abrasive, to cut almost any material without heat.

Metal Stamping

Metal stamping presses sheet or strip between a punch and a die to blank, pierce and form parts in seconds.