Skip to main content
SNIJER

Part of Sheet Metal Fabrication

Metal Stamping⁠

Metal stamping presses sheet or strip between a punch and a die to blank, pierce and form parts in seconds. It is the most economical process for high-volume sheet metal parts once tooling is built.

About this service

Progressive and single-stage dies produce identical parts at high speed. The tooling is an investment, so stamping pays off from a few thousand pieces; below that, laser cutting and bending are usually cheaper.

We help you decide: we quote the same part both ways, and design dies with sheet-metal and wire-EDM expertise so that tool life and part quality are balanced from the start.

Key capabilities

  • Progressive and single-stage dies
  • High-speed, repeatable output
  • Piercing, blanking, forming and coining
  • Die design with EDM expertise

Typical applications

  • Clips, brackets and terminals
  • Washers, shims and small housings
  • High-volume enclosure parts

Materials

  • Mild steel
  • Stainless steel
  • Aluminium
  • Copper and brass

Frequently asked questions

From what quantity does stamping pay off?

As a rule from a few thousand pieces, when the cost of the die is spread over enough parts. We quote laser-cut-and-bent and stamped versions side by side so you can compare.

Related services

Laser Cutting

Laser cutting melts or vaporises sheet metal along a programmed path with a focused beam, giving fast, accurate cuts with fine…

Water Jet Cutting

Water jet cutting uses a high-pressure stream of water, usually mixed with abrasive, to cut almost any material without heat.

Metal Bending

Metal bending folds flat sheet along straight lines with a press brake to form angles, channels and boxes.