Skip to main content
SNIJER

Part of Injection Molding

Overmolding⁠

Overmoulding moulds a second material, usually a soft TPE or rubber, over a rigid plastic base part. It adds grip, sealing, vibration damping and a finished look in a single bonded component.

About this service

Material pairing decides success: the overmould must bond chemically or mechanically to the substrate. We select compatible combinations — for example PC/ABS with TPE — and design interlocking features where chemical bonding is not available.

Overmoulding replaces separate seals, grips and bumpers, reducing assembly steps and failure points.

Key capabilities

  • Soft-touch grips and seals in one part
  • Compatible material pairing
  • Mechanical interlocks where needed
  • Fewer assembly steps

Typical applications

  • Handheld tools and devices
  • Sealed housings
  • Vibration-damped mounts

Materials

  • PC, ABS, PC/ABS, PA substrates
  • TPE / TPU overmould
  • Silicone (LSR)

Frequently asked questions

What is the difference between overmolding and insert molding?

In overmoulding a plastic is moulded over another plastic part. In insert moulding the part being encapsulated is usually metal — a thread, pin or contact — placed in the mould before injection.

Related services

Insert Molding

Insert moulding places a pre-made part — typically a metal thread, pin, contact or bushing — in the mould and moulds plastic…