Skip to main content
SNIJER

Part of Sheet Metal Fabrication

Water Jet Cutting⁠

Water jet cutting uses a high-pressure stream of water, usually mixed with abrasive, to cut almost any material without heat. There is no heat-affected zone, so the material keeps its properties and shape.

About this service

In abrasive water jet cutting, water pressurised to several thousand bar is forced through a small nozzle and mixed with fine garnet. The jet erodes the material along the programmed contour, leaving a smooth, burr-free edge with no thermal distortion or hardening of the cut face.

It cuts metals, stainless steel, aluminium, titanium, composites, glass, stone, ceramics, rubber and plastics, in thicknesses from thin foil to well over 100 mm. Tolerances are tight enough for most fabrication work, and parts that were previously cut by laser or plasma can be re-cut without heat to restore edge quality.

Where it fits

Choose water jet when the material must not be heated, when it is thick or reflective, when it is not metal at all, or when a single set-up has to handle many materials. It also suits prototypes and small series, because no tooling is needed.

Key capabilities

  • Cold cutting: no heat-affected zone
  • Metals, composites, stone, glass and ceramics
  • Smooth, burr-free edges
  • No tooling needed for prototypes and small series
  • Sharp internal corners and complex contours

Typical applications

  • Thick plate and heat-sensitive alloys
  • Composite and carbon fibre panels
  • Gaskets, seals and stone or glass inlays

Materials

  • Steel and stainless steel
  • Aluminium and titanium
  • Composites and carbon fibre
  • Stone, glass and ceramics
  • Rubber and plastics

Frequently asked questions

What is water jet cutting?

Water jet cutting is a cold cutting process in which a high-pressure jet of water, usually carrying abrasive grains, erodes material along a programmed path. It does not heat the part, so there is no heat-affected zone.

Which materials can a water jet cut?

Almost any: steel, stainless steel, aluminium, titanium, copper, composites, carbon fibre, glass, stone, ceramics, rubber and plastics. Tempered glass shatters and some brittle materials need special piercing.

Related services

Laser Cutting

Laser cutting melts or vaporises sheet metal along a programmed path with a focused beam, giving fast, accurate cuts with fine…

Metal Bending

Metal bending folds flat sheet along straight lines with a press brake to form angles, channels and boxes.

Metal Stamping

Metal stamping presses sheet or strip between a punch and a die to blank, pierce and form parts in seconds.